#Repetier server command a download#

Print surface diameter/2 minus unreachable space (avoid collisions with vertical towers). Horizontal distance bridged by diagonal push rods when effector is centered.ġ22 #define DELTA_RADIU (DELTA_SMOOTH_ROD_OFFSET-DELTA_EFFECTOR_OFFSET-DELTA_CARRIAGE_OFFSET+ 2.0） =160-34-25+2

* To help you better understand the 4 values, you can refer to the scheme. and processor overload (too many expensive sqrt calls).ġ13 #define DELTA_SMOOTH_ROD_OFFSET 160.0 【2】ġ16 #define DELTA_EFFECTOR_OFFSET 34.0【3】ġ19 #define DELTA_CARRIAGE_OFFSET 25.0【4】 This is a trade-off between visible corners (not enough segments) Make delta curves from many straight lines (linear interpolation). Please pay close attention to the red numbers. #define DELTA and modify the values as below. Click Configuration.h and find out Delta Settings

#Repetier server command a download#

( If you do not have Arduino IDE, you can download here.)Ĥ. We have pre-loaded the firmware to GT2560 before shipping, but as this is a DIY printer, there may be some subtle difference between each printer, so you need to modify the firmware to fit your exact printer for better printing effect.ġ.

(the distance between the nozzle and the print bed). You may have to adjust this for many times to keep the center point and its around point in one plain. If the nozzle touches the around points but not the center point, you should increase the DELTA_RADIUS If the nozzle touches the center point but not the around points, you should reduce the DELTA_RADIUS Adjust the distance between the nozzle and the print surface, keep the center point and its around point in one plain.ġ22 #define DELTA_RADIUS (DELTA_SMOOTH_ROD_OFFSET-DELTA_EFFECTOR_OFFSET-DELTA_CARRIAGE_OFFSET+2.0） If the 3 numbers differ too much, you can manually move down the print head until the nozzle just hit the print bed, and screw the endstop screw tightly, if the screw has no room to adjust, you need to change the following setting later, record it. it is 2.7mm in my case.ģ)send G 0 X-43.3 Y-25 Z2, record the distance；e.g. it is 3mm in my case.Ģ)send command: G0 X43.3 Y-25 Z2， record the distance；e.g. 1)send command： G0 X0 Y50 Z2， record the distance；e.g.